Ready to hand embroider your keepsake ornament? Follow the steps below!
What's included in your kit:
- 3" embroidery hoop
- needle
- embroidery floss
- fabric with customized pre-drawn design in hoop
- exclusive QR code for video instructions
Helpful Tips:
- be sure to split your embroidery floss (AKA thread) down to 2-3 strands (instead of the 6 that it comes cut off in)
- if your thread gets tangled in the back, no worries! Just cut it below the knot, get the loose thread to the back of the hoop, then re-thread your needle and start again!
- Remember! This is YOUR keepsake, you stitching it is what makes it special and something to pass on for generations!
STEPS:
1. CLICK this link for video tutorial youtu.be/OEFL6Url9SQ
2. Split your floss down to 2-3 strands
3. Thread your needle (leaving about 2-3 inches coming out of the eye) and tie a knot on the tail end of your fabric
4. Complete your stitching
5. Cut off any excess fabric from around the hoop
6. Use an iron to remove any pen marks from the stenciled design
7. Tie ribbon around metal part of hoop to create a loop and a bow (2 steps)
8. Hang on your tree and enjoy your new hobby!
**9. send me a picture because I can't wait to see what you create!
- 3" embroidery hoop
- needle
- embroidery floss
- fabric with customized pre-drawn design in hoop
- exclusive QR code for video instructions
Helpful Tips:
- be sure to split your embroidery floss (AKA thread) down to 2-3 strands (instead of the 6 that it comes cut off in)
- if your thread gets tangled in the back, no worries! Just cut it below the knot, get the loose thread to the back of the hoop, then re-thread your needle and start again!
- Remember! This is YOUR keepsake, you stitching it is what makes it special and something to pass on for generations!
STEPS:
1. CLICK this link for video tutorial youtu.be/OEFL6Url9SQ
2. Split your floss down to 2-3 strands
3. Thread your needle (leaving about 2-3 inches coming out of the eye) and tie a knot on the tail end of your fabric
4. Complete your stitching
5. Cut off any excess fabric from around the hoop
6. Use an iron to remove any pen marks from the stenciled design
7. Tie ribbon around metal part of hoop to create a loop and a bow (2 steps)
8. Hang on your tree and enjoy your new hobby!
**9. send me a picture because I can't wait to see what you create!
